Slide Gates are used for controlling the grain flow. There are manuel, electrical & pneumatic models that fit to the requested tonnage. While powered gates are being used in places where are harfd to be reached, manuel gates are oppositely used in easy places. Should pneumatic system is available in system, pneumatic gates can be used instead of electrical slide gates. Manuel gates are also used for tonnage adjusting of system. Gates are produced in welded condition. They can easily be installed and removed. Slide inside the gate, which is produced from polyamide, is openning and closing the flow line of grain by moving on the rolls.

Valves are used to canalize the flowing grain and to increase the number of flow line from 1 to 2 or 3 lines. 6' - 8' - 10' or 12' valves are produced according to the requested capacity. Valves are produced in welded condition. They can easily be affixed/removed. By means of the tube orienting mechanism, flow line is got under the control.

Elbow is used for changing grain flow angle. 6" (168mm), 8" (219 mm), 10" (273 mm) diameters and 15°, 22.5°, 30°, 45° angles, produced in welded condition

Spouting Pipe
Fast-flowing grain, eats away the section where it hits. Flowing graing in long-distance, empierces the section it comes accross. Spouting pipe (velocity brake) is used to prevent this. Grain hits to the grain rather than sheet section by filling the inner-side of spouting pipe. Thus, attrition is minimized by means of the same type of materials.
Spouting Pipe is produced in welded condition in diameters of 6" (18mm), 8" (219 mm), 10" (273 mm) & 12" (323 mm). End cover of it where the grain fills can be removed, so replacement of it, is possible. Therefore, costs are minimized instead of replacing the whole material.

Adapters harmonize different dimensioned and shaped materials which are used in grain flow system. These are produced in welded condition, 6", 8", 10" & 12" according to the requested capacity.

Y Spout, Y Right Spout, W Spout

These are used to canalize the grain flow and to increase the flow lines from 1 to 2 or 3. These are produced in welded conditions, in dimensions of 8", 10" & 12".

Inlet Plate is used in entrances of some machines that are used in grain conveying as conveyor, unloading auger. Requested capacity is considered as basic criteria when it is produced 6", 8", 10" & 12"

Flowing Pipe & Truss Kit

Required way for flowing of the grain is provided by using the flowing pipes. These are produced in the diameters of 6" (168 mm), 8" (219 mm), 10" (273 mm) & 12" (323 mm)
Truss Kit is used for preventing the bulge of flowing pipes in long distances. The quantity of truss kit, varies according to the diameter.